Qyt Kt7900d Service Manual Instant

The manual specifies a test point labelled "LOCK". It should be high (3.3V or 5V). If low or pulsing, the VCO is unlocked. Follow the VCO alignment procedure from section 4.2.

The manual’s voltage chart shows that the 13.8V input goes through a reverse-protection diode (D1) and then to a 5V regulator (U2). Measure pin 3 of U2. If 0V, D1 is open. qyt kt7900d service manual

The display works, so the MCU is likely alive. But audio? The manual’s schematic shows that the audio path from the speaker amplifier (IC6) is separate from the MCU. Inject a 1kHz tone at the volume IC input; if you hear it on a scope but not the speaker, the amplifier IC or speaker wire is bad. The manual specifies a test point labelled "LOCK"