Set gain to 0-6dB (no higher, or noise appears). Iris should be manual: F5.6 to F8.0 for deep depth of field.
Attach a compatible CS-mount lens (recommended: 6-60mm varifocal for day watching). Ensure the sensor is clean. Use the included shim if back-focus is off. fu10 day watching 18 install
Run a full day of recording. At sunset, review 1 hour of footage from 12 PM (peak sun). Check for blown highlights or underexposed shadows. Adjust exposure compensation by ±0.3 if needed. Troubleshooting Common FU10 Day Watching Issues Even with the perfect 18-install, you may encounter hiccups. Here’s how to solve them: Set gain to 0-6dB (no higher, or noise appears)
Press and hold the reset pinhole for 10 seconds until you hear two beeps. This ensures no legacy settings interfere with day-watching profiles. Ensure the sensor is clean
Via the on-screen display (OSD), set a static IP (e.g., 192.168.1.100). Disable DHCP to prevent address changes mid-installation.
For daylight, set shutter to 1/500s (for moving objects) or 1/2000s (for very bright conditions). Avoid 1/60s—it creates motion blur.
Enable RTSP on port 554. Test ONVIF compatibility with your NVR. For mobile access, forward port 8080 (but use a VPN for security).